Please Note: If movies do not play your browser does not support the Video Tag.
You can update your browswe or click on the link below the movie to watch it in a different formate.
Warning All Brakes Should be Installed by a competent gunsmith!! The most important thing is that the bore is true (Straight) to the exit port hole in the brake and that the exit hole is larger than the bullet size. If not you will get a bullet strike which we are not responsible for!!
3 Port Large Maxi Muzzle Brake - 60% Reduction in felt recoil! **For barrels larger than .750 at the muzzle.
Pictured above In 416 Satin Stainless Steel
Pictured above In Black Oxide 4140 CM Steel
Pictured above In 416 Brushed Stainless Steel
A) Is the side view above left.
B) Is the angled side view with the small 3 top ports visible.
C) Is Looking down at the top of the muzzle brake with the 3 small top holes fully visible.
There are no bottom holes which makes the muzzle brake a good choice for prone shooters.
Length is 2.8", Width is 1.293" at the front and .950" at the rear tapered end.
This brake not only nullifies the rearward motion, But also keeps the muzzle linear so your target stays in the sight picture in your scope.
Comes in 5/8 x 24 TPI Threads Only.
Brake must be indexed for proper alignment of holes.
Gunsmith installation is recommended but we do offer a back up nut for indexing the brake yourself for $5.99.
Offered in bullet exit hole size of.250" for 223 calibers & .340" for 30 calibers which can be opened for larger calibers. ** Please specify size when ordering below..
**We can open up the exit hole here for other size calibers or you can have your gunsmith do this for you will when they install your brake.
If you are not sure of the caliber call before ordering.